Chapter 5 — Troubleshooting and Maintaining the CK31
CK31 Handheld Computer User’s Manual 123
Problems While Scanning Bar Codes (continued)
Problem Solution
Your 1551E or 1553 scanner
stopped working after you activated
energy saver mode or connected a
cable.
You can enable energy saver mode only if the
scanner is connected to the CK31 by the energy
saver cable P/N 3-606032-03. Follow these steps:
1 Disconnect the scanner from the CK31.
2 Find the Reset Factory Defaults bar code in the
scanner documentation.
3 While pulling the trigger, hold the scanner over
the Reset Factory Defaults bar code, and apply
external power to the scanner. The scanner is
reset to factory defaults.
4 Use Intermec Settings to disable energy saver
mode on the CK31.
5 Use Intermec Settings to disable the port.
6 Attach the scanner to the CK31.
7 Use Intermec Settings to enable the port.
8 Use the scanner to scan a bar code. The scanner
should work now, but energy saver mode is
disabled. Continue with Steps 9 through 11
only if you want to use energy saver mode.
9 Install the P/N 3-606032-03 energy saver cable.
10 Use Intermec Settings to enable energy saver
mode on the CK31.
11 Use the scanner to scan a bar code. Energy saver
mode is enabled.
To Next Page
Loading...
