Intermec CK31

Chapter 1 — Using the CK31 Handheld Computer
34 CK31 Handheld Computer User’s Manual
2 Select or clear the symbologies you want to use and tap Back.
3 If you want to enable symbologies not shown on the Scanner
Symbologies window, tap Intermec Settings. Intermec
Settings appears on your screen.
4 From the Intermec Settings application, go to Scanners,
Symbologies > Internal Scanner > Symbologies.
5 Enable or disable any of the symbologies you want to use.
6 Save your settings and close Intermec Settings. The Scanner
Symbologies window reappears.
7 Tap Back.
8 Scan bar code labels.
Installing the SD Card
You can use a Secure Digital (SD) card to increase file storage
and install software. The CK31 currently supports SD cards that
hold up to 1 GB of information. The SD card slot is located on
the top of the CK31 just above the laser scanner window.
To insert an SD card
1 Press I to turn off the CK31.
2 Unscrew the two captive screws on the SD card door and
remove the door.
3 Gently insert the SD card into the CK31 with the printed
side facing the keypad and screen side of the CK31.