Chapter 2 — Configuring the CK31
72 CK31 Handheld Computer User’s Manual
To use WEP security, you need:
• a CK31 handheld computer with an 802.11b/g radio.
• an access point with an 802.11b/g radio.
Configuring Static WEP Security With Funk Security
1 Make sure you have selected Funk as your security choice.
2 Make sure you have configured the communications and
radio parameters on your CK31.
3 Open Intermec Settings.
4 Choose Communications > 802.11 Radio > Funk Security
> Profile.
5 For Association, choose Open and then press Enter.
6 For Encryption, choose WEP and then press Enter.
7 For 8021x, choose None and then press Enter.
8 Define a value for the keys you want to use. You can define
up to four keys (Key 1 through Key 4).
Enter an ASCII key or a hex key that is either 5 bytes or 13
bytes long depending on the capability of the radio. Set a 5-
byte value for 64-bit WEP or a 13-byte value for 128-bit
WEP. Hex keys must be preceded by 0x and contain 5 or 13
hex pairs.
9 For Transmit key, choose the key you want to use for
transmitting data.
10 Exit Intermec Settings.
Configuring Static WEP Security With Microsoft Security
1 Make sure you have configured the communications and
radio parameters on your CK31.
2 Open Intermec Settings.
3 Choose Communications > 802.11 Radio > Microsoft
Security.
4 For Network Authentication, choose Open.
5 For Data Encryption, choose WEP.
To Next Page
Loading...
