Intermec PM23c User Manual

Appendix B — Default Settings
138 PM23c, PM43, and PM43c Mid-Range Printer User Manual
Clip Default Determines if the printer prints items
outside the printable area of the label.
When this is set to Off, the printer returns
an error if any part of a bar code label
cannot be printed because that part extends
beyond the printable area. When this is set
to On, the printer prints all bar code labels,
but may also print unreadable, incomplete
labels.
Off
Start Adjust Sets the length of media the printer feeds
(positive value) or retracts (negative value)
before printing a label. Unit of
measurement is defined in the Unit of
Measure parameter. Range is -9999 to
+9999.
0
Stop Adjust Sets the length of media the printer feeds
(positive value) or retracts (negative value)
after printing a label. Unit of measurement
is defined in the Unit of Measure parameter.
Range is -9999 to +9999.
0
Media
Calibration
Mode
Selects the mode the printer uses to
calibrate media. Use Slow if the printer has
trouble identifying gaps or marks in media.
Fast
Length (Slow
Mode)
If Media Calibration Mode is set to Slow,
the printer prints the media length plus 10
mm. This value sets an additional amount
of media to be printed. Unit of
measurement is defined in the Unit of
Measurement parameter. Range is 0 to
3200.
0
LTS
Sensitivity
Level
Sets the sensitivity of the label taken sensor.
Range is 0 to 14. Supported when the
Cutter or Label Dispenser accessories are
installed.
0
Media Settings (Continued)
Setting Description Default

Intermec PM23c Specifications

General

Brand	Intermec
Model	PM23c
Category	Printer
Language	English