Appendix B — Default Settings
PM23c, PM43, and PM43c Mid-Range Printer User Manual 143
System Maintenance Alert Settings
This section describes the system maintenance alert settings, such as
the odometer distance. To view these settings:
• From the printer Main Menu, select Settings > System Settings >
Maintenance Alerts.
• From the printer web page, click the Configure tab, System
Settings > Maintenance Alerts.
SmartSystems Determines if the printer can be managed by
Intermec SmartSystems Foundation.
Enable
SNMP Determines if the printer can use SNMP. Enable
LPR Determines if the printer can use the line printer
server (LPR) daemon.
Enable
IKEv2 Determines if the printer can use IKEv2. Disable
SSH Determines if the printer can use Secure Socket
Handling (SSH).
Enable
Telnet Determines if the printer can use Telnet. Enable
System Network Services (Continued)
Service Description Default
System Maintenance Alert Settings
Setting Description Default
Odometer (User
Resettable)
Sets the length of media (in meters) that the
printer prints before the Odometer (User
Resettable) alert is sent, if this alert is
configured. Unit of measurement is defined
in the Unit of Measure parameter. Range is 0
to 4294967295.
0
Odometer (Printer) Sets the length of media (in meters) that the
printer prints before the Odometer (Printer)
alert is sent. Unit of measurement is defined
in the Unit of Measure parameter. Range is 0
to 4294967295.
0
To Next Page
Loading...
Need help?
General