Intermec PM4I Installation Instructions

EasyLAN Wireless Interface Kit Installation Instructions 29
Chapter 4 — Setup in Fingerprint
Changing User
To change the current user in Fingerprint, the “su”command is used.
Syntax:
RUN"su [-p <password>] <user>"
su requests the password for <user>, and switches to that user after
checking the password fi le.
Valid <user> names are admin and user.
Everyone can become user even if user’s password is set.
No password is requested if the current user already is the one to switch
to.
 e option is as follows:
-p password Don’t query for a password; use the one supplied at
the command line.
Note: Everything is case sensitive (user name, su command,
passwords).
Examples:
To become “admin”.
RUN"su admin"
Password:[enter password (default: pass)]
Ok
Or:
RUN"su -p pass admin": RUN"whoami"
admin
To switch back to user:
RUN"su user"

Intermec PM4I Specifications

General

Print Technology	Direct thermal / Thermal transfer
Resolution	203 dpi
Max Print Width	4.09 inches
Connectivity	USB, Serial, Parallel
Optional Connectivity	Ethernet, Wireless
Memory	16 MB SDRAM, 8 MB Flash
Operating Temperature	+5°C to +40°C (+41°F to +104°F)
Storage Temperature	-20°C to +60°C (-4°F to +140°F)