Intermec EasyLAN Wireless—Interface Kit Installation Instructions 23
4
Setup in IPL
This chapter explains how to set up the wireless
network communication in printers running IPL
v2.10 (or later). The only requirement on the PC side
is a terminal program that can transmit and receive
ASCII characters on an RS-232 line. Thus, this
method is recommended when you do not have the
opportunity to run the Intermec EasyLAN Network
Setup wizard, for example because you use some other
operating system than Windows.
For information on how to set up the network
communication in printer’s running Fingerprint, refer
to Chapter 3.
To Next Page
Loading...
