Chapter 3 — SR31T Interfaces
SR31T Tethered Scanner User’s Guide 21
2 Connect the power supply to the cable and an AC power outlet if
you are using the externally powered USB cable.
3 If your host device is off, turn it on. The scanner beeps twice, the
green LED flashes to indicate the USB interface being used and
the scanner vibrates (see the Understanding the Lights and
Understanding the Beeps and Vibrate Alert explanations in
Chapter 2).
4 If necessary, use the configuration bar codes in the next section to
configure your SR31T for an International keyboard. The default
keyboard is North America.
USB cable with power jack
Note: If you are using a non-powered USB cable, you may get a
message that the host does not provide enough power. For example
when you connect the USB cable to a keyboard hub or if there are
other USB devices connected. In this case use a different hub or
disconnect other USB devices. Otherwise use a powered USB cable.
To Next Page
Loading...
Need help?
General
