Intermec SR31T - Setting up the RS-232 Interface; Baud Rate

Chapter 3 — SR31T Interfaces
SR31T Tethered Scanner User’s Guide 27
5 If necessary, use the configuration bar codes in the next section to
configure your SR31T serial parameters to match the PC.
The default serial parameters for the SR31T are:
Setting up the RS-232 Interface
This section provides configuration bar codes for a basic setup. All bar
codes marked with (*) indicate the default value. Additional
configuration options are available with the EasySet scanner setup
software (see Chapter 4, Configuring Your Scanner with EasySet).
Baud Rate
38400
57600 (*)
115200
128000
230400
Serial Parameter Default Setting
Baud rate 57600
Data bits 8
Parity None
Stop bits 1