Chapter 3 — SR31T Interfaces
24 SR31T Tethered Scanner User’s Guide
USB Cable Mode
By default the USB cable mode is set to Keyboard HID. However you
can also set up your scanner to use the following USB cable modes:
• HID POS
• IBM POS Hand Held
• IBM POS Table Top
• Virtual COM
USB Keyboard HID (*)
)
HID POS
IBM POS Hand Held
IBM POS Table Top
USB Virtual COM
Note: When scanning a USB Cable Mode configuration bar code, the
scanner beeps twice then restarts. When it restarts, the scanner will
beep twice, flash a series of green flashes to indicate the USB cable
mode selected (see “Status Light” on page 11), and vibrate.
To Next Page
Loading...
