Intermec SR31T - Basic Setup with Configuration Bar Codes

Chapter 4 — Configuring the SR31T Scanner
34 SR31T Tethered Scanner User’s Guide
Basic Setup with Configuration Bar Codes
This chapter provides you with configuration bar codes for a basic
setup. For more configuration options, use EasySet (see Configuring
Your Scanner with EasySet in this chapter).
Resetting Your Scanner
To reset your scanner, read the reset factory defaults configuration
bar code.
Reset factory defaults
Configuring the Postamble
The default postamble is <CR> <LF>. For certain applications or
when using USB Keyboard HID you may need to change this setting.
Use the following configuration bar codes to change the default
postamble in your scanner.
Carriage Return + Line Feed (*)
None
Carriage Return
Enter