28
Version 2.1 (08/2013) en
Translation of the original instructions
RollerDrive EC310
Appendix
Installation Declaration
in accordance with the EC Machinery Directive 2006/42/EC, Appendix II B
The manufacturer:
hereby declares with sole responsibility that the product range
• RollerDrive EC310
is not a ready-to-use machine as defined by the EC Machinery Directive
and, therefore, does not fully comply with the requirements of this
directive. The commissioning of these conveyor modules is not permitted
until conformity of the entire machine/system in which they are installed
has been declared in compliance with the EC Machinery Directive.
The health and safety requirements as stated in Appendix I have been applied.
The special technical documents as stated in Appendix VII B have been compiled
and will be sent to the responsible authority if necessary.
Person authorized to compile the technical documents: Georg Malina,
Interroll Engineering GmbH, Hoeferhof 16, D - 42929 Wermelskirchen
Applied EC directives:
• Machinery Directive 2006/42/EC
• EMC Directive 2004/108/EC
• RoHS Directive 2002/95/EC
Applied harmonized standards:
• EN ISO 12100 Parts 1 and 2 "Safety of machinery - Basic concepts, general
principles for design" - Part 1: "Basic terminology, methodology" -
Part 2: "Technical principles"
Wermelskirchen, 31st March 2010
Armin Lindholm
(Managing Director)
(This declaration can be obtained at www.interroll.com, if needed.)
Interroll Engineering GmbH
Hoeferhof 16
D - 42929 Wermelskirchen
Germany
To Next Page
Loading...
Need help?
General
