inVENTer Connect. - Page 38

38
OPERATION AND SET-UP ON THE CONTROLLER
inVENTer Connect controller platform | Operating instructions
Activating the boost function globally
TIP: To activate boost mode, the same steps as for activating pause mode must be carried out,
except that the boost / pause key must be pressed once more to activate the boost symbol.
Requirements:
• The "System information" display screen of any
ventilation zone, here ventilation zone 1, standard
zone, is called up.
► Press the Boost/Pause key.

The auto symbol ashes on the display screen.
► Press the Boost/Pause key.

On the display screen, the pause symbol ashes
and at the same time the
pause function time setting (timer) appears.
► Press the Boost/Pause key again.

On the display screen, the boost symbol starts
ashing:

At the same time, the boost function time setting
(timer) appears.
► Press the up and down arrow keys to set
the desired time for boost mode.
When setting the boost time, you can choose
between 1, 2, 4 and 8 hours.