EasyManuals Logo

INVENTOR COOL User Manual

INVENTOR COOL
184 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #10 background imageLoading...
Page #10 background image
7
Introduction for b uttons on rem ote controller
Note:
hen power is connected(stand by condition), you can operate the air conditioner
through the remote controller.
hen unit is on, each time you press the button on remote controller, the sending
signal icon " " on the display of remote controller will blink once. If the air con-
ditioner gives out a beep sound, it means the signal has been sent.
hen unit is off, set temperature will be displayed on the remote controller (If the
light of indoor unit display is turned on, the corresponding icon will be displayed)
hen unit is on, it will display the icon of the ongoing function.
Press this button to turn unit on/off.
ON /OFF button
1
Pressing this button once can select your required mode circularly as below (the
corresponding icon   will be lit up after the mode is selected):
hen selecting auto mode, air conditioner will operate automatically according to
ambient temperature. et temperature cant be adusted and wont be displayed
either. Press A button to adust fan speed.
hen selecting cool mode, air conditioner will operate under cool mode. Then
press  or  button to adust set temperature. Press A button to adust fan speed.
hen selecting dry mode, air conditioner will operate at low fan speed under dry
mode. In dry mode, fan speed cant be adusted.
hen selecting fan mode, air conditioner will operate in fan mode only. Then
press A button to adust fan speed.
hen selecting heat mode, air conditioner will operate under heat mode. Then
press  or  button to adust set temperature. Press A button to adust fan speed.
(Cooling only unit can’t receive heating mode signal. If set AT mode by remote
controller, press  button can’t turn on the air conditioner.)
AUTO COOL DR FAN H EAT
MOD E button
2
Pressing  or  button once will increase or decrease set temperature by 1°(°C).
old  or  button for 2s, set temperature on remote controller will change quickly.
Release the button after your required set temperature is reached.
hen setting Timer n or Timer ff , press  or  button to adust the time.(ee
TIR utton for setting details)
+ / - button
3

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the INVENTOR COOL and is the answer not in the manual?

INVENTOR COOL Specifications

General IconGeneral
BrandINVENTOR
ModelCOOL
CategoryAir Conditioner
LanguageEnglish

Related product manuals