INVENTOR COOL User Manual

13
Malfunction analy sis
Please check below items before asking for maintenance. If the malfunction still
can’t be eliminated, please contact local dealer or qualied professionals.
Phenomenon Troubleshooting Solution
Air conditioner
can' t operate
Air conditioner
can' t receive
signal from
remote contr-
oller or remote
controller is
not sensible.
Poor cooling
(heating)
● Power failure
● hether the unit is interfered
seriously (such as static pres
sure, unstable voltage)
● hether remote controller is
within the receiving range
● hether its blocked by obst
acles
● Is sensitivity of remote contr
oller low
● hether there’s uorescence
lamp in the room
● Is the power too low
●
hether the air lter is too dirty
● hether the set temperature is
proper
● hether door and window are
closed
● Is plug loose
● hether the air switch is trip
ped off or fuse is burnt
● Is theres malfunction for the
circuit
● hether the unit is restarted up
after stopping immediately
● ait after power recovery.
● Please pull out the plug. Ins
ert the plug after about 3min,
and then turn on the unit.
●
The receiving range of remote
controller is m. Do not ece
ed this range.
● Remove the obstacles.
● Check the batteries of remote
controller. If the power is low,
please replace the batteries.
● ove the remote controller
close to air conditioner.
●
Turn off the uorescence lamp
and try it again.
●
ait after voltage is resumed.
● Clean the air lter.
● Adust the temperature.
● Close door and window.
● Reinsert the plug.
● Ask professional person to
replace air switch or fuse.
● Ask professional person to
replace circuit.
● ait for 3min, and then turn
on the unit again.

INVENTOR COOL Specifications

General

Brand	INVENTOR
Model	COOL
Category	Air Conditioner
Language	English