10
R eplacem ent of b atteries in rem ote controller
Note:
● During operation, point the remote control signal sender at the receiving
window on indoor unit.
●
The distance between signal sender and receiving window should be no more
than 8m, and there should be no obstacles between them.
● ignal may be interfered easily in the room where there is uorescent lamp
or wireless telephone remote controller should be close to indoor unit during
operation.
● Replace new batteries of the same model when replacement is required.
● hen you don’t use remote controller for a long time, please take out the
batteries.
● If the display on remote controller is fuy or there’s no display, please
replace batteries.
reinstall
remove
battery
cover of battery bo
1. Press the back side of remote controller on the
spot marked with " " , and then push out the
cover of battery bo along the arrow direction.
2. Replace two o. (AAA 1.5) dry batteries and
make sure the positions of + and- polar are
correct.
3. Reinstall the cover of battery bo.
To Next Page
Loading...
Need help?
General
