INVT GD300L-004G-4 User Manual

Goodrive300-LIFT series inverter Fault tracking
-99-
Code
Fault
Possible cause
Solution
The keypad wire is too
long and affected by
strong interference.
There is circuit fault on
the communication of the
keypad and main board.
Check the environment and
avoid the interference
source.
Change the hardware and
ask for service.
UPE
Parameters
uploading fault
The connection of the
keypad wires is not good
or broken.
The keypad wire is too
long and affected by
strong interference.
Communication fault.
Check the keypad wires
and ensure whether there is
mistake.
Change the hardware and
ask for service.
Change the hardware and
ask for service.
DNE
Parameters
downloading fault
The connection of the
keypad wires is not good
or broken.
The keypad wire is too
long and affected by
strong interference.
There is mistake on the
data storage of the
keypad.
Check the keypad wires
and ensure whether there is
mistake.
Change the hardware and
ask for service.
Repack-up the data in the
keypad.
E-DP
PROFIBUS
communication fault
Communication address
is not correct.
Corresponding resistor is
not dialed
The files of main stop
GSD does not set sound
Check related setting
E-NET
Ethernet
communication fault
The Ethernet address is
not set right.
The Ethernet
communication is not
selected to right.
The ambient interference
is too strong.
Check the relative setting.
Check the communication
method selection.
Check the environment and
avoid the interference.
E-CAN
CANopen
communication fault
The connection is not
sound
Check the connection
Draw out the correspond

INVT GD300L-004G-4 Specifications

General

Brand	INVT
Model	GD300L-004G-4
Category	Inverter
Language	English