INVT Goodrive200A Series User Manual

GD200A series VFD Function parameters
-68-
Function
code
Name
Description
Default
value
Modify
P07.02
QUICK/JOG
function
selection
Ones: Function of QUICK/JOG key
0: No function
1: Jogging. Press QUICK/JOG to begin the
jogging running.
2: Shift the display state by the shifting key. Press
QUICK/JOG to shift the displayed function code
from right to left.
3: Shift between forward rotations and reverse
rotations. Press QUICK/JOG to shift the direction
of the frequency commands. This function is only
valid in the keypad commands channels.
4: Clear UP/DOWN settings. Press QUICK/JOG
to clear the set value of UP/DOWN.
5: Coast to stop. Press QUICK/JOG to coast to
stop.
6: Shift the running commands source. Press
QUICK/JOG to shift the running commands
source.
7: Quick commission mode(committee according
to the non-factory parameter)
Note: Press QUICK/JOG to shift between forward
rotation and reverse rotation, the VFD does not
record the state after shifting during powering off.
The VFD will run according to parameter P00.13
during next powering on.
Tens: Keypad lock selection
0: Do not lock keypad buttons
1: Lock all the keypad buttons
2: Lock part of the keypad buttons (lock PRG/ESC
key only)
Note: If the tens is 1, press PRG+DAT keys three
times, and all the keypad buttons will be locked;
Keep DAT key pressed down while pressing V key
three times can unlock keypad buttons.
Setting range: 0x00–0x27
0x01
◎
P07.03
Shifting
sequence
selection of
QUICK/JOG
When P07.02=6, set the shifting sequence of
running command channels.
0: Keypad control→terminals control
→communication control
0
○

INVT Goodrive200A Series Specifications

General

Brand	INVT
Model	Goodrive200A Series
Category	DC Drives
Language	English