- 28 -
2. Ping Base Setting :
⚫ Ping Interval : The number of seconds ( Sec., 1~9999 ) between each ping .
⚫ Response Time Out : The number of milliseconds ( ms. ,1~9999) of the device will wait for a
response from the Pinged device if no ping is detected within this time it will be considered a
Ping failure.
⚫ Ping After Action Delay : After ping finished , do the action after setting seconds ( Sec. )
⚫ Action Max. repeat times： Setup the times of Action after Ping Failure .
Set 0 means action non stop - Keep action & no limit times.
As setting finished , please click “ Apply “ to save the setting in this area , the webpage will
refresh and user can see the final setting result. Ten different set up rules for different port .
3. Other Setting :
The setting here is for each rule .
To Next Page
Loading...
