CAUTION Use only qualified cables with a IP67 connector provided by your
Service Provider with the Iridium Edge connectors. Failure to do so would
create an improper seal, allowing moisture and water vapor to enter the
device which in turn could lead to corrosion and damage to the device. This
could cause the device to fail, and could result in injury or damage.
NOTICE The Iridium Edge must be powered through a fuse or current-
limited power supply. Failure to do so could cause large current drawings if
unexpected or inadvertent shorts occur in either Iridium Edge device or its
mating cable. Any large sustained current could result in damage to
equipment.
1 Regulatory and Standards Compliance
Iridium Edge is certified as Model #9680. It is designed to comply with the standards for the United
States, Canada, European Union, and Australia/New Zealand as per the table below.
Table 1-1 Regulatory and Technical Certifications.
ETSI EN 301 489-20 V1.2.1 (2002-11)
ETSI EN 301 489-1 V2.1.1 (2017-02)
To Next Page
Loading...
