Iridium EDGE - Radio Frequency Radiation Safety Notice and Other Information Required by the U.s. Federal Communications Commission and Other Governments

15
EN 550022 :2010/AC :2011
EN61000-4-2 : 2009 ( Electrostatic Discharge)
EN61000-4-3 : 2010 ( Radiated RF Immunity)
EN61000-4-4 : 2012 ( Electrical Fast Transient)
EN61000-4-6 : 2014 ( Conducted RF Immunity)
EN61000-4-8 : 2010 (Magnetic Immunity)
EN55022:2010/AC :2011
Safety
EN60950-1:2006/A2:2013
EN623311:2008
RoHS
RoHS 2:2011/65/EU
FCC
FCC 47 CFR Part 25 (Contains a modular approved device: FCC ID Q639603N)
FCC 47 CFR Part 15, Subpart B
Industry
Canada
(ISED
Canada)
ISED RSS 170. (Contains Modular approved device: IC 4629A-09603N)
ICES-003, Issue 5 : 2012
Australia/NZ
AS/NZS CISPR 22 (2009) + A1:2010
ACMA HES Standard (2014)
.
1.1 RADIO FREQUENCY RADIATION SAFETY NOTICE AND OTHER
INFORMATION REQUIRED BY THE U.S. FEDERAL COMMUNICATIONS
COMMISSION AND OTHER GOVERNMENTS
Certifications in most regions, including the United States, require that the Iridium Edge must be installed
such that it is at least 20 cm (7.87 inches) away from persons. Users are advised that this device must not
be collocated with or operated in conjunction with any other antenna or transmitter than the one contained
in this device, unless so permitted by the equipment authorization procedures of the U.S. Federal
Communications Commission (FCC).
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
1) This device may not cause harmful interference, and
2) This device must accept any interference received, including interference that may cause
undesired operation.