IRIS IRMA MATRIX Door Clear

18
/30
IRMA MATRIX Door Clear option | Mounting and operating instructions
released
Rev. 1.3
2018-08
Fig. 19: Exit Door Clear configurator
3.3 Applying Door Clear in the Config Tool
Close the DC configurator before opening the Config Tool. The sensor can only
communicate with one tool at a time.
The “Door Clear” tab is only active in the Config Tool if Door Clear was previously retrieved
in the DC configurator. In the “Door Clear” tab, you will find the Door Clear zone setting.
Quit the Door Clear configurator
using EXIT.
Exit Door Clear configurator