IRIS IRMA MATRIX Door Clear

19
/30
IRMA MATRIX Door Clear option | Mounting and operating instructions
released
Rev. 1.3
2018-08
Fig. 20: “Door Clear” tab in the Config Tool
Open the Config Tool. If
necessary, check the
firmware version to
avoid a compatibility
issue (see p.
11).
In the “Installation” tab,
set all parameters
according to the
installation situation.
(For this, see
KDIA_IRMA-
MATRIX_R2_Installation
-manual-CAN (ETH)_1.3,
available at
https://www.irisgmbh.
de/en/technical-
documents/irma-
matrix/
Then check the Door
Clear parameters under
“Door Clear”, amend
them if necessary and
click ANWENDEN
(= apply).