I A P 2 0 2 3 . 0 0 1 - A F M / I R I S T E X A N I I P A G E | 157
FOR SIMULATION USE ONLY ā NOT A TRAINING AID
Knee Board Lights
Knee board lights are mounted on the front of each forward and aft glare shield.
The knee board lights are controlled individually. Each light is turned on when the
light assembly is positioned downward for usage and turned off when moved to the
stowed position.
Light intensity may be adjusted by rotating the bezel assembly. Each knee board
light is swivel mounted and can be repositioned for convenience.
Power for the knee board lights is provided through circuit breakers, placarded
UTIL in the front cockpit and UTIL LT in the rear cockpit. The circuit breakers are
located on the battery bus circuit breaker panel in each cockpit.
EXTERIOR LIGHTING
The aircraft is equipped with exterior lighting that meets the requirements for
operation of the aircraft during night and low light conditions.
Landing and Taxi Lights
The landing light is located aft and inboard of the left main landing gear strut, and is
exposed as the landing gear is extended. The landing light is oriented to provide
ground illumination and visibility during landing.
The landing light illuminates only when all three gear are down and locked.
Control of the landing light is through a toggle switch, placarded LDG, located on
the trim control panel in the front cockpit. The landing light control switch head
features three bumps to assist in identifying the switch by feel.
Power for the landing light is provided through a circuit breaker, placarded LDG,
located on the battery bus circuit breaker panel in the front cockpit.
The taxi light is located aft and inboard of the right main landing gear strut and is
exposed as the landing gear is extended. The taxi light is oriented to provide ground
illumination and visibility during landing and taxi operations.
The taxi light illuminates only when all three gear are down and locked.
Control of the taxi light is through a switch, placarded TAXI, located on the trim
control panel in the front cockpit. Power for the taxi light is provided through a
circuit breaker, placarded TAXI, located on the generator bus circuit breaker panel
in the front cockpit.
To Next Page
Loading...