I A P 2 0 2 3 . 0 0 1 - A F M / I R I S T E X A N I I P A G E | 158
FOR SIMULATION USE ONLY – NOT A TRAINING AID
Navigation and Anti-Collision Strobe Lights
The navigation lights include a red light installed at the leading edge of the left wing
tip, a green light installed at the leading edge of the right wing tip, and a white light
installed at the trailing edge of each wing tip.
The navigation lights are controlled by a switch, placarded NAV, located on the trim
control panel in the front cockpit.
Power for the navigation lights is provided through a circuit breaker, placarded
NAV, located on the generator bus circuit breaker panel in the front cockpit.
The anti-collision strobe lights are installed on each wing tip near the leading edge.
The anti-collision strobe lights are controlled by a switch, placarded ANTI-COLL,
located on the trim control panel in the front cockpit.
Power for the anti-collision strobe lights is provided through a circuit breaker,
placarded COLL, located on the battery bus circuit breaker panel in the front
cockpit.
SYSTEM/LAMP TEST PANEL
A system/lamp test panel is located aft of the CFS handle panel on the left console
panel in the front cockpit. The system/lamp test panel includes the following
momentary switches:
A lamp test switch which illuminates LAMP TEST status messages on the
EICAS display; the master caution, master warn, and fire annunciators; the
landing gear control handle and gear lights; the transmit lights on the audio
control panel; and FDR lights.
A lamp test switch for the rear cockpit lamps is located on the left console
panel in the rear cockpit.
An auxiliary battery test switch which checks the voltage of the auxiliary
battery and the AUX BAT light. Turn the BAT switch ON and then hold the AUX
BAT test switch. If the light illuminates when the switch is activated, the
auxiliary battery is charged to an acceptable level and is flight capable.
If the light does not illuminate, the auxiliary battery is at less than 50%
capacity.
An AOA system test switch which, when set to HIGH, configures the AOA
indexers, indicator, and stick shaker indications to simulate a high AOA
condition.
To Next Page
Loading...