I A P 2 0 2 3 . 0 0 1 - A F M / I R I S T E X A N I I P A G E | 89
FOR SIMULATION USE ONLY ā NOT A TRAINING AID
Display for the VOR or ILS frequency is provided on the Up Front Control Panel
(UFCP), Primary Flight Display (PFD), and Navigation Display (NAV).
Power for the VHF NAV receiver is provided through a circuit breaker, placarded
VHF NAV, located on the generator bus circuit breaker panel in the front cockpit.
The active frequency is displayed on W3 of the UFCP persistent display, as well as
on the PFD and NAV pages when selected as NAV source DISTANCE MEASURING
EQUIPMENT (DME) The distance measuring equipment (DME) system provides
ground station distance measuring capability based on the VOR frequency selected.
DME mode selection is provided by controls on the UFCP.
The DME provides distance to the station. Display for the DME is provided on the
UFCP, PFD, and NAV display. Power for the DME system is provided through a
circuit breaker, placarded DME, located on the generator bus circuit breaker panel
in the front cockpit.
To Next Page
Loading...