32
in the retaining clip.
4. Reconnect power to the controller.
Manual Operations
Semi-Automatic Program Operation
Semi-Automatic Program operation enables an automatic Program water-
ing cycle to be started manually at any time. Once running, the manual
advance feature enables you to step through the programmed station
sequence.
1. Place the Function switch in the Run position.
2. Turn the Dial to the Current Time position.
3. Place the Program switch to select A, B or C.
4. Press the Semi-Auto button to start the watering cycle.
Note: Once started, the station sequence can be manually advanced
by placing the Dial to Current Time and pressing the Manual but-
ton.
Note: The Manual Advance feature applies to all Automatic, Semi-
automatic and Station Test watering operations for the selected
Program.
Note: To terminate watering operations, place the Function switch
momentarily in the OFF or Stop position.
Manual Station Operation
Manual station operation provides manual control at the individual station
level and provides the following four control options:
• Station(s) can be operated for a one-time run duration without
altering the station’s set run time in an automatic Program.
• Operation can be limited to only one station running manually
or set to allow three stations to run at the same time.
Note: Refer to “Stack/Overlap Option” on page 26 for additional
information regarding manual operations.
• Works with the Manual Advance feature to move up through the sta-
tion sequence.
1. Place the Function switch in the Run position.
2. Turn the Dial to the Station Number to be manually operated.
To Next Page
Loading...
Need help?
General
