To Next Page

To Previous Page

3. Use the / buttons to set a manual operation run time ranging

from 1 minute to 5.9 hours.

4. Press the Manual button to start the operation.

5. If this is the only station to be run manually, skip step 6 and

continue at step 7 below.

6. To add additional stations to the manual run operation, repeat steps

2 through 4 as needed, then continue at step 7.

Note: Depending upon the Stack/Overlap setting, additional

stations selected (beyond the one or three option setting) will regis-

ter as OFF when entered with the Manual button. However, they will

be placed (stacked) in the manual sequence to run.

7. Turn the Dial to the Current Time position.

Note: Once started, the station sequence can be manually advanced

by pressing the Manual button.

Note: To terminate manual watering operations, place the Function

switch momentarily in the OFF or Stop position.

Clear Program Memory

The Clear Program Memory feature enables you to safely clear the

automatic watering program settings defined for a specific Program

without affecting any remaining Program information. The memory erase

function applies only to the specified Program, leaving the remaining

Programs intact.

Important: The “Clear Program” function completely erases

all user-defined programming information from the selected

Program including: start times, run times, and watering day

schedule.

Note: To reset the controller (all Programs) to factory default

settings, refer to “Restore Rain Dial-R to Factory Default Settings” on

page 35.

1. Place the Function switch in the Set Programs position.

2. Place the Program switch to select A, B or C.

3. Turn the Dial to the Skip Days - Special Functions position.

4. Press the Manual button repeatedly to display CLr (Clear).

5. Press the button one time. The display will show the prompt:

CL? (Clear?).

Irritrol Rain Dial-R User Manual

Other manuals for Irritrol Rain Dial-R