Each output channel is completely transistorized and well-regulated, and
works in constant voltage (CV) or constant current (CC) mode. Even at
the maximum output current, a fully rated, continuously adjustable output
voltage is provided. For a big load, the power supply can be used as a
CV source; while for a small load, a CC source. When in the CV mode
(independent or tracking mode), output current (overload or short circuit)
can be controlled via the front panel. When in the CC mode (independent
mode only), the maximum (ceiling) output voltage can be controlled via
the front panel. The power supply will automatically cross over from CV
to CC operation when the output current reaches the target value. The
power supply will automatically cross over from CC to CV when the
output voltage reaches the target value. For more details about CV/CC
mode operation, see page 14.
The front panel display (CH1, CH2) shows the output voltage or current.
When operating in the tracking mode, the power supply will automatically
connect to the auto- tracking mode.
When used in audio production lines, the power supply will provide a
continuous or dynamic load using a jumper connector (JP101/JP401)..
When the connectors are connected to the position “ON”, a stable DC
current power will be provided for audio power amplifiers.
To Next Page
Loading...
