ISET<x>:<NR2> Sets the value of current.
VSET<x>:<NR2> Sets the value of voltage.
ISET<x>? Return the value of current.
VSET<x>? Return the value of voltage.
IOUT<x>? Returns actual output current，
VOUT<x>? Returns actual output voltage.
TRACK<NR1> Sets the output of the power supply working on
independent or tracking mode.
BAUD<NR1>Set the value of baud rate.
RCL<NR1> Recall the setting data from the memory which previous
saved.
SAV<NR1> Saves the setting data to memory.
BEEP<Boolean> Sets the BEEP state on or off.
OUT<Boolean> Sets the output state on or off.
LOCAL Return to local mode
*IDN？ Returns instrument identification.
ERR？ Returns instrument error messages.
STATUS？ Returns the power supply state.
All response time estimates are based on a baud rate of 115200bps.
Expect longer response times with a baud rate of 57600bps.
To Next Page
Loading...
