Iso-Tech IPS 3303D - General Safety Guidelines

IPS X303 Series Instruction Manual
6
Safety Guidelines
General
Guidelines
CAUTION
 Do not place any heavy object on the IPS X303 series.
 Avoid severe impacts or rough handling that leads to damaging the
IPS X303 series.
 Do not discharge static electricity to the IPS X303 series.
 Do not block or obstruct the cooling fan vent opening.
 Do not perform measurement at circuits directly connected to Mains
(see note below).
 Do not disassemble the IPS X303 series unless you are qualified as
service personnel.
(Measurement categories) EN 61010-1:2001 specifies the measurement
categories and their requirements as follows. The IPS X303 series falls
under category I.
 Measurement category IV is for measurement performed at the
source of low-voltage installation.
 Measurement category III is for measurement performed in the
building installation.
 Measurement category II is for measurement performed on the
circuits directly connected to the low voltage installation.
 Measurement category I is for measurements performed on circuits
not directly connected to Mains.
Power Supply
WARNING
 AC Input voltage: 100V/120V/220V/230V ±10%, 50/60Hz
 Connect the protective grounding conductor of the AC power cord to
an earth ground, to avoid electrical shock.
Fuse
WARNING
 Fuse type: 100V/120V: T6.3A/250V, 220V/230V: T3.15A/250V
 Make sure the correct type of fuse is installed before power up.
 To ensure fire protection, replace the fuse only with the specified type
and rating.
 Disconnect the power cord before fuse replacement.
 Make sure the cause of fuse blowout is fixed before fuse replacement.
Cleaning the IPS
X303 series
 Disconnect the power cord before cleaning.
 Use a soft cloth dampened in a solution of mild detergent and water.
Do not spray any liquid.
 Do not use chemicals or cleaners containing harsh products such as
benzene, toluene, xylene, and acetone.