Instructions LED LED State
1. Unlock the datAshur Personal
2
with Admin PIN
Red solid LED followed by a flickering Green
LED indicating successful Admin PIN entry
2. Press the KEY button twice (double-click)
Blue LED blinking ready to receive new PIN
3. Within 10 seconds begin to enter your New User PIN
Blue LED continues to blink
4. Press KEY button twice (double-click)
Green LED blinks
5. Within 10 seconds begin to re-enter the New User PIN
Green LED continues to blink
6. Press KEY button twice (double-click)
Off
Red LED quickly fades out to indicate
successful creation of a New User PIN
Admin PIN requirements:
• Must be between 7-15 digits in length
• Must not contain only repetitive numbers, e.g. (3-3-3-3-3-3-3)
• Must not contain only consecutive numbers, e.g. (1-2-3-4-5-6-7), (7-8-9-0-1-2-3-4), (7-6-5-4-3-2-1)
14. How to change the Admin PIN
Once an Admin PIN has been created, the datAshur Personal
2
needs to be unlocked in Admin mode in order to change the
Admin PIN. The Admin PIN cannot be changed from the User mode.
Instructions LED LED State
1. Unlock the datAshur Personal
2
with existing Admin PIN
Red solid LED followed by a flickering Green
LED indicating successful Admin PIN entry
2. Press and hold down the number 1 button and press the
KEY button twice (double-click) (1 &
)
&
Red and Blue LED’s flicker together ready to
receive new Admin PIN
3. Within 10 seconds begin to enter your New Admin PIN
&
Red and Blue LED’s continue to flicker together
4. Press KEY button twice (double-click)
Green LED blinks
5. Within 10 seconds begin to re-enter the New Admin PIN
Green LED continues to blink
6. Press KEY button twice (double-click)
Red solid LED changing to a flickering Green
LED indicating successful Admin PIN change
Admin PIN requirements:
• Must be between 7-15 digits in length
• Must not contain only repetitive numbers, e.g. (3-3-3-3-3-3-3)
• Must not contain only consecutive numbers, e.g. (1-2-3-4-5-6-7), (7-8-9-0-1-2-3-4), (7-6-5-4-3-2-1)
Caution: Entering the Admin PIN to access a locked drive will clear the User PIN. For security reasons, we
highly recommend that a new User PIN be created immediately once the drive has been unlocked
using the Admin PIN. Refer to section 13 on page 11.
Note: If a mistake was made while defining a new Admin PIN or the procedure was not completed, the drive
will retain the old Admin PIN.
To Next Page
Loading...
Need help?
General