Overview
Copyright ©ITECH Electronic Co., Ltd. 9
Chapter1 Overview
This chapter introduces the front panel, the rear panel, key functions and LCD
display function of the IT8200 series load, make sure that you can quickly know
the appearance, instruction and the key function before you operate the load.
Help you make better use of this series of load.
1.1 Brief Introduction
Adopting advanced SiC technology, IT8200 Series is a regenerative
programmable AC/DC electronic load. It is power regenerative, which not only
saves electricity and cooling costs for you, but also good for energy saving and
environmental protection. AC load mode supports both rectification andnon-
rectification, providing CC/CR/CP/CS/CC+CR/CE operating modes. It can
simulate multiple circuit topologies under CE mode such as single-phase
rectification RLC Circuit and parallel RLC Circuit. IT8200 can be applied to the
test of V2G, EVSE, PCS, UPS, inverter, etc.
IT8200 Series adopt a high power density design, and the power can reach
15kVA in a 3U unit. After parallelconnection, the power can be extended to
960kVA at most.Its LCD touch screen with graphical UI interface can directly
define differentwaveforms. Combined with arbitrary waveform editing function
and perfect protection function, it is an ideal choice for R&D testing andsystem
construction.
⚫ Adopt advanced SiC technology
⚫ High power density, 15kVA in 3U unit
⚫ Measure up to 16 parameters including Vrms/Arms/Freq/CF/PF/UTHD/
ITHD/±Vpeak.
⚫ Master/Slave parallel, power up to 960kVA
⚫ High efficient energy regeneration
⚫ Voltage - 350 VL-N
⚫ Comprehensive working modes selectable: single-phase,three-phase,
reversed phase. Rated voltage can be extended to 200% under reversed
phase
⚫ Frequency: 16-500Hz
⚫ Support NORMAL/LIST/SWEEP/Surge&Sag modes
⚫ Built-in various waveforms
⚫ Touch screen, simple UI for easy operation
To Next Page
Loading...
Need help?
General