Installation
Copyright ©ITECH Electronic Co., Ltd. 27
Connecting the DUT (Local Measurement)
The instrument supports two kinds of wiring methods with the DUT: local
measurement and remote measurement (Sense). The default test mode is local
measurement.
NOTE
The T8230-350-180 consists of two 15kVA in parallel mode. The input terminals
and Remote sense terminals use the master interface. The wiring method is the
same as other models.
Please confirm that the Remote Sense function in the menu is set to Off,
otherwise the instrument will report an error in the present connection mode.
⚫ The connection diagram of single phase is shown as follow:
NOTE
When the input voltage has DC voltage, the input terminal L is positive, and N is negative.
⚫ When used as a three-phase power output, the Y connection mode is used
as an example, The connection diagram is shown as follow:
When Delta connection mode is selected in the system menu, the N wire
does not need to be connected.
To Next Page
Loading...
Need help?
General
