System-Related Functions
Copyright ©ITECH Electronic Co., Ltd. 65
The default set is in ON mode.
Set the screen brightness
This item can set the screen brightness. Set the screen brightness within the
range 1 to 10 by pressing number keys on the front panel. The larger the number
is, the higher the screen brightness is. You can also set the screen brightness
by rotating the knob on the front panel.
Restored to Factory Setting
This menu item is used to restore some parameter settings to factory setting
values.
The procedures to set the menu item are as follows.
1. Select the General under system menu.
2. Press Enter in Factory_default_settings. After the parameter settings are
complete and return to main interface.
Set the Power-on State
This parameter determines the state of the instrument after power up.
The procedures to set the menu item are as follows.
1. Press the General under the system menu.
2. Press the Up/Down key or turn the knob to select the Power-on setup and
press [Enter].
⚫ Reset: Default value, indicates when the instrument is powered on, the
instrument will initialize some parameter settings or state, such as input
voltage, start phase and stop phase.
⚫ Last: Indicates when powered on, the instrument will remain the same
parameter settings and input status as last time you powered off the
instrument.
⚫ Last+Off: Indicates when powered on, the instrument will remain the same
settings as last time you powered off the instrument, but the input status is
Off.
Lock the Touch Screen
This parameter determines the state of the touch screen.
1. Press the General under the system menu.
2. Press the Up/Down key or turn the knob to select the Touch screen lock and
press [Enter].
⚫ On: enable the touch screen
⚫ Off: disable the touch screen
Set the Load Speed
This configuration item can set the speed of the load loop to suit different DUT.
Set the Knob Function
Set the knob setting function. If set to ON, the Knob setting will take effect
immediately. If set to OFF, press Enter to confirm the effect after the Knob setting
is completed.
To Next Page
Loading...
Need help?
General