List Commands
Copyright © Itech Electronic Co., Ltd. 102
Query Syntax
[SOURce:]LIST:SLEW[:BOTH]? <NR1>
Returned Parameters
<NR3>
Related Commands
CURR:SLEW VOLT:SLEW RES:SLEW
[SOURce:]LIST:WIDth
This command sets the sequence of list dwell times. Each value represents the
time in seconds that the input will remain at the particular list step point before
completing the step. If times exceed 16383S, the input remains at the present
level until a trigger sequences the next point in the list. Else At the end of the
dwell time, the input automatically changes to the next point in the list.
Command Syntax
[SOURce:]LIST:WIDth <NR1>, <NRf>
Parameters
1 to steps, 20uS to max
Unit
NONE, s (seconds)
Examples
LIST:WID 1, 0.02 LIST:WID 2, 0.5
Query Syntax
[SOURce:]LIST:WIDth? <NR1>
Returned Parameters
<NR3>
[SOURce:]LIST:SAV
This command stores the present list file of the electronic load to a specified
location in memory. Up to 5 files can be stored. file in saved in locations 1-5 are
volatile, the data are nonvolatile, the data will be saved when power is
removed.
To Next Page
Loading...
Need help?
General
