ITech IT8700 Series - [Source:]Voltage:latch; [Source:]Voltage:high; [Source:]Voltage:low

SOURce Subsystem
Copyright © Itech Electronic Co., Ltd. 84
[SOURce:]VOLTage:LATCh
This command sets the action type of Von.
Command Syntax
[SOURce:]VOLTage:LATCh[:STATe] <b>
Parameters
0 | 1 | ON | OFF
*RST Value
ON
Examples
VOLT:LATC 1
Query Syntax
[SOURce:]VOLTage:LATCh[:STATe]?
Returned Parameters
0 | 1
Related Commands
VOLT:ON
[SOURce:]VOLTage:HIGH
[SOURce:]VOLTage:LOW
This command set the high and low current limit when the load is in constant
voltage mode.
Command Syntax
[SOURce:]VOLTage:HIGH <NRf+>
[SOURce:]VOLTage:LOW <NRf+>
Parameters
MINimum through MAX | MINimum | MAXimum | DEFault
Unit
A (amps)