ITech IT8700 Series - [Source:]Remote:sense; [Source:]Function

SOURce Subsystem
Copyright © Itech Electronic Co., Ltd. 69
Returned Parameters
<NR3>
Related Commands
INP:TIM
[SOURce:]REMote:SENSe
This command is used to select the remote measure mode for the load.
Command Syntax
[SOURce:]REMote:SENSe[:STATe] <BOOL>
Parameters
0 | 1 | OFF | ON
*RST Value
0
Examples
REM:SENS 0
Query Syntax
[SOURce:]REMote:SENSe[:STATe]?
Returned Parameters
<CRD>
[SOURce:]FUNCtion
These equivalent commands select the input regulation mode of the electronic
load.
 CURRent constant current mode
 RESistance constant resistance mode
 VOLTage constant voltage mode
 POWer constant power mode
Command Syntax
[SOURce:]FUNCtion <function>
Parameters
CURRent | RESistance | VOLTage | POWer