ITRON Gen 5 500W ERT - Page 24

1. Connect the 500WERTModule wires to the register using gel-cap connectors following
the 500WERTModule to the Badger ADE register wire connections (see Encoder-type
Register Connections on page 13). The 500WERTModule has three wires that connect to
the register.
2. To wire the 500WERTModule to the RTR 2-wire register, connect the 500WERTModule
wires to the 2-wire register using gel-cap connectors.
3. After the wires are connected, carefully tuck the connectors into the 500WERTModule
housing.
4. Place the 500WERTModule on the register, ensuring that the edge of the
500WERTModule housing is seated properly around the perimeter of the register as
shown.
Gen5 500WERTModule Remote Installation Guide 3 Setting up and Installing
December 5, 2022 LDI-0343 REV002 Itron, Inc. Page 24 of 48