ITRON Gen 5 500W ERT - Direct Mounting on Badger Meters

7. After the wires are connected, carefully tuck the connectors into the 500WERTModule
housing.
8. Tighten all screws securely.
9. Install the module and mounting bracket on the meter register adapter collar.
10. Replace the hollow pin (1) you removed in step 1.
Direct Mounting to a Badger Direct Mount Register
Note: Verify you have a Badger meter with a register designed for direct mount remote modules. Check
the part number on the label to verify the module matches the meter. Always install the module with the
arrow on the housing pointing upward. The register may or may not be mounted on the meter when
performing the following steps.
Gen5 500WERTModule Remote Installation Guide 3 Setting up and Installing
December 5, 2022 LDI-0343 REV002 Itron, Inc. Page 23 of 48