ITRON Gen 5 500W ERT - Mounting on the Adapter Plate

the top. If the pipe is at a 45-degree angle up to the right, install the adapter plate with the
mounting screws (2) as shown.
If the pipe is at a 45-degrees angle up to the left, install the adapter plate as shown.
If the pipe is horizontal, install the adapter plate as shown.
Mounting on the Adapter Plate
1. Locate the two 1-inch 500WERTModule mounting screws in the pipe mount kit.
2. Slide the 500WERTModule back cover onto the adapter, pushing up to secure the lug
adapter in the lug slot.
Gen5 500WERTModule Remote Installation Guide 3 Setting up and Installing
December 5, 2022 LDI-0343 REV002 Itron, Inc. Page 27 of 48