ITRON Gen 5 500W ERT - Page 40

Event ID Event name Event description
511 Load Profile
Cleared
Load Profile object has been cleared. The specific causes of this event are:
■
Transitioning from 100S (Run, Factory, Quiet)to IoT mode, or from IoT to 100S
mode.
■
Setting Interval size to a new value (IoT mode only)
■
Setting count rate, initial index, PCOMP, Rollover,
EncoderDriv500WERTModuleype (100S or COSEM) to a new value.
512 Manual Time
Sync
Time has been changed manually.
515 Time Sync – over
threshold
detected
Time change is greater than warning level threshold.
Qualifies as an active event.
516 Time Sync – over
threshold end
Time change is greater than warning level threshold back below threshold.
517 Entering 100S
Mode
The device has been changed from Network mode to 100S Mode.
1000 Meter - Register
Removal
Badger Extended Alarm: Bit 0 = register removal.
1001 Meter -
Temperature
Alarm
Badger Extended Alarm: Bit 1 = temperature alarm.
1002 Meter - End of
meter life
Badger Extended Alarm: Bit 2 = end of life alarm.
1003 Meter - Zero
Consumption
Detected
Badger Extended Alarm: Bit 3 = no usage alarm.
1004 Meter - Reverse
Flow Meter
Badger Extended Alarm: Bit 4 = reverse flow alarm.
1005 Meter - Leak
Meter Alarm
Badger Extended Alarm: Bit 5 = leak alarm.
Is an alarm by default.
1006 Meter - Encoder
Programming
Badger Extended Alarm: Bit 6 = program alarm.
1007 Meter - Tamper Badger Extended Alarm: Bit 7 = tamper.
1500 Meter - Active
Reverse Flow
Kamstrup Extended Alarm Byte1: Bit 0 = Active reverse flow.
Gen5 500WERTModule Remote Installation Guide B Events and Alarms
December 5, 2022 LDI-0343 REV002 Itron, Inc. Page 40 of 48