ORBIMAT CA | Operating instructions Operation
(09.03.15) OW_ORBIMAT_CA_BA_871060202_04_EN orbitalum tools GmbH, D-78224 Singen, www.orbitalum.com, Tel. +49 (0) 77 31 792-0 51
Selecting a TIG manual welding torch
CAUTION: Programming via "Auto programming" not possible!
1. In the main menu, select "Manual/Adjust programming" > "Parameter adjustments" > "Basic adjustments".
2. Select and highlight the "Weld head model" field.
The list of weld head models appears in the display:
The connected manual torch is detected automatically.
3. If the manual torch is not detected: Select weld head
model from the list and save it.
4. Press softkey 1 ("Weld").
The machine is ready to start.
Fig. 25: Manual torch selection
8.8.4 External remote control
Connecting a remote control
1. Removing the dummy plug in remote control connection of the machine.
2. Connect remote control.
1
1. Emergency-stop switch
2. Function keys
Fig. 26: Remote control
8.8.5 External printer (A4)
LPT connection: On back of machine, labeled "Printer".
Internal printer driver/character set: HPGL
To Next Page
Loading...