10
2.2.2 ALARM UNSETTING
Note: If the “Unset section by authorization only during entrance delay” parameter is enabled, then mere
authorization will unset a section where the entrance delayed has been triggered. This option should be
used with caution when using multiple sections.
Consult the installation with a service technician in order to program the desired behaviour of the system.
2.2.3 PARTIAL ALARM SETTING
WARNING: This is an additional function of the alarm system.
The system can also be confi gured to be partially set which allows guarding only by certain detectors in
a section.
Example: At night, it is possible to set the door and window detectors only, while selected motion detectors
will not trigger the alarm when somebody moves inside the section.
1. When you enter the building
(triggering a detector with a
“Delay” reaction), the system starts
indicating an entrance delay with
a continuous tone, the system
indicator and a function button,
both fl ashing red, of the section in
which the delayed entrance has
been triggered.
2. Authorize yourself using the
keypad – the system indicator
will start fl ashing green.
3. Press the function buttons of
the sections you want to unset.
4. The command is executed.
The function buttons and the
system indicator turn green
to indicate unset sections.
1. Authorize yourself using
the keypad (enter a code or hold
an RFID tag up to the reader).
The system indicator button will
start fl ashing green.
2. Press the function button of
the selected section.
3. The command is executed
and the function button turns
permanently yellow to indicate
a partially set section.
2. OPERATING THE JA-10 SYSTEM
To Next Page
Loading...
