JAC J2 - Page 101



Maintenance Manual for J2 Sedan
Mechanical Part of Engine
100
assembly.
4)
Install
oil
filter.
■
Clean
the
oil
filter
mounting
surface
on
oil
pump
housing.
■
Apply
some oil on O-ring of oil
filter
.
■
Tighten
oil
filter until
the
O-ring seating on
the
installation surface;
re-tighten the
oil filter
by 0.75
lap or get the tightening torque to 11 ± 1N • m.
Attention
:
■
The oil
filter must
be tightened with
filter spanner.
If the
filter is
tightened by
hand, oil
leakage
may occur due to inadequate tightening torque.
5) Install oil pan.
■
Clean
cylinder block
and
oil pan
mating surface
to
ensure that
there are
no
oil and
other impurities.
■
Apply
sealant
as
shown
in
diagram
below.
■ Specified sealant:
L
T5699 or
equivalent.
Oil pan

Apply
sealant
as shown in
figure.
Fig. 1.2.010