JAC J2 User Manual



Maintenance Manual for J2 Sedan
Service
16
②

Take off air
filter
element.
2) Inspection After Dismantlement
■ The air filter must be
regularly
cleaned or
replaced
according to recommended schedule. Please
refer to “Regular Service”.
■
Blow bac
k of
air filter
element
with compressed air until nothing can
be blow
n away.
3) Installation
Install with steps
contrary to dismantlement.
7. Replacement
of
Engine
Oil
Attention:
■
Be ca
reful
not
to be
scalded
since
oil tempera
ture
is
high.
■ Long-time direct contact between skin and the used oil should be avoide
d. In case
contacted,
wash with soap or detergent thoroughly as soon as possible.
1)
Warm up
the engine, an
d check for any oil
leakage in t
he engine com
partment. Refe
r to “Leakage of
engine oil”.
2)
Stop
engine
and wait
for
ten minutes.
3)
Loosen
engine
oil fil
ler cap,
and the
n remove
the oil
drain screw
plug.
4)
Discharge
engine
oil.
5) Install the
oil
drain screw plug
with
new gasket.
Attention:
■
Any dirt such as
iron debris
on oil drain
screw
plug must be
cleaned, a
nd new
gaskets
should be installed.
■
Tightening
torque
of
oil
drain
bolt:
34-44
N·m.
6)
Refill
new
oil.
For specification and viscosity of
engine oil, please refer to “Recommended Oil and Lubricant”.
■
Engine
oil
quantity:
3.8L
Attention:
■ During th
e filli
ng of
engine
oil, please do n
ot re
move oil gage.
■
The filling
amount of
engine
oil may
vary according
to oil
temperature and
oil drain
time.
Quantity above is for reference only.
Fig. 2.2.006

JAC J2 Specifications

General

Brand	JAC
Model	J2
Category	Automobile
Language	English