JAC J2 User Manual



Maintenance Manual for J2 Sedan
Service
17
■ Oil rule should be used all the w
ay to chec
k whethe
r the filling
amount of e
ngine oil
is
proper.
7) Warm up
the engine, ch
eck areas around the oil drain screw plug and o
il filter for leak
age.
8) Stop
engine
and wait
for
ten minutes.
9)
Inspect
oil
level.
See
also
“Engine
oil
level”.
8.
Change
Oil
Filter
1) Dismantlement
①

Use oil filter wrench to
dismount
the
filter.
Attention:
■ JAC original engine oil or equivalent product
should
be used.
■
Be car
eful not to be scalded since
engine
and oil are hot.
■ During dismantlement, a
cloth should
be prep
ared to
wipe up the leaked or splashed oil.
■ Please
keep
the
driving
belt free from
engine
oil.
■
Clean
any
oil
splashed
on
engine
and
vehicle.
2) Installation
①
 Clear any foreign substance on mounting
surface of oil filter.
②

Paste a film o
f engine oil o
nto the oil seal
surface of new filter.
③
 Tighten.
■
Tightening
torque:
10-12N·m
Attention:
■ The
engine
oil
filter
must be
tightened
with
a
filter
wrench.
■ Manual
tightening ma
y cause
oil leak
age
due to
the ina
dequate
tightening torque
.
3)
Post-installation
inspection
①

Inspect oil l
evel, and fi
ll engine
oil when
it is inade
quate. See
also “Engine
Oil”.
②

Start
engine,
check
for
any
oil
leakage.
③

Stop engine and wait
for
ten minutes.
④

Inspect oi
l level,
and f
ill en
gine o
il. See
also
“Engine
Oil”.
9.
Replacement
of
Ignition
Plug
Fig. 2.2.007

JAC J2 Specifications

General

Brand	JAC
Model	J2
Category	Automobile
Language	English