JAC J2 User Manual



Maintenance Manual for J2 Sedan
Service
20
■ In case any component is
found
damaged,
repair or replace.
2. Inspection of Clutch Fluid Level and Leakage
If the fluid level is low, check clutch system for any
leakage.
3.
Inspection
of
Clutch
System
Check for correct installation positions of liquid pipelines and operation cylinders, and any crack,
damage, loose connection, worn or
ageing.
4.
Inspection
of
Manual
Transmission
Gear
Oil
Inspect oil level and whether there is any leakage. For detailed information, refer to “Inspection of
Manual Transmission Oil”.
5.
Change
Manual
Transmission
Gear
Oil
1) Thoroughly drain oil from drain plug,
and then
refill with new gear oi
l. For detaile
d informa
tion, refer
to “Change Manual Transmission Oil”.
2)
Inspect oil
level. For d
etailed in
formation,
refer to
“Inspection o
f Manu
al Transm
ission Oil
Level”.
6.
Wheel
Balance
1) Dismantlement
①

Dismount
the
wheel(s)
need
to
be
adjusted.
②

Dismount
the old bal
ance block
s from bo
th sides of
the wheel,
clear any foreig
n matters f
rom treads
of tyre.
Note: for new tyre(s), the
tape on the tyre should be removed.
Attention:
■
During
dismantlement, be careful not
to
scratch
the
tyre.
2)
Adjusting
wheel
balance
①

Take the
center hole a
s guide
to install the
wheel on
balancer. Start t
he balancer.
②

When
unbalance values of both inner side and outer side of
tyre have been
indicated on the display
of wheel balancer, multiply the unbalance value of outer side with 5/3,
so as to define the weight of
balance blocks which will be actually applied. Then, select the outer side balance block of which
Fig. 2.2.009

JAC J2 Specifications

General

Brand	JAC
Model	J2
Category	Automobile
Language	English