Jacuzzi J-13 - Page 29

29
HOLD MODE (STANDBY)
The HOLD (standby) feature stops the system from
operang automacally, allowing for convenient
filter cartridge removal and replacement.
The following pads must be pressed.
1. Press TEMP
2. Press LIGHT repeatedly unl “HOLD” appears
3. Press TEMP to start 60 minute count down
PROGRAMMING READY / REST MODE
To change the factory default filter cycle sengs
1. Press TEMP
2. Press LIGHT repeatedly unl MODE appears
3. In MODE, TEMP buon toggles between SET
READY and SET REST
4. Choose SET READY or SET REST, then press
LIGHT to set and exit.
PROGRAMMING (connued)
SETTING THE CLOCK
At the main screen, begin by pressing TEMP
1. Press LIGHT repeatedly unl TIME appears
2. Press TEMP at TIME (HRS begin to flash)
3. Press TEMP keys to change hours
4. Press LIGHT (minutes begin to flash)
5. Press TEMP keys to change minutes
6. Press LIGHT to exit
HOLD MODE (STANDBY - CONTINUED)
The system will automacally exit HOLD (Standby)
Mode aer 1 hour and resume normal operang
funcons.
Press then the pad - the display will flash.
If the system is heang when HOLD (Standby)
Mode is acvated, the display will flash and the
pump will connue to operate for 15 seconds to
allow the heater to cool off before stopping.
TEMPERATURE RANGES
The TEMP feature allows you to select a low and
high temperature range depending on your climate
and me of year. The sengs are as follows:
High Range can be set between 27°C (80°F) and 40°
C (104°F) in 1° increments.
Low Range can be set between 10°C (50°F) and 37°
C (99°F) in 1° increments.
To change your selecon press the following
sequence.
1. Press TEMP
2. Press LIGHT repeatedly unl TEMP appears
3. Press TEMP to select the range (HIGH “^” or
LOW “v”)
4. Press LIGHT to lock in the Temperature Range