Jacuzzi J-13 - Page 30

30
INVERT (FLIP)
This features allows you to flip the display towards
the interior of the swim spa. Pressing the following
sequence of keys will FLIP the display.
1. Press TEMP
2. Press LIGHT repeatedly unl FLIP appears
3. Press TEMP to flip the display
4. Press LIGHT to exit
PURGE (CLEAN-UP) CYCLES
When a pump is turned on by a buon press, a
clean up cycle begins 30 minutes aer the pump is
turned off or mes out. The pump and ozone
generator will run for 20 minutes or more,
depending on the system.
FREEZE PROTECTION
If the temperature sensor detects a drop to 4°C
(39°F) within the heater chamber, the system
automacally acvates the pump to provide freeze
protecon. The pump will operate unl the
temperature reaches approximately 5°C (41°F)
before returning to normal system mode.
LOCK (RESTRICTING PANEL OPERATION)
Locking the panel prevents the spa from being
used; it also prevents unwanted temperature
adjustments. All automac funcons are sll
acve/ Locking the Temperature allows jets and
other features to be used, but the set temperature
and other programmed sengs cannot be
adjusted.
1. Press TEMP
2. Press LIGHT repeatedly unl LOCK appears
3. Press TEMP
4. Press LIGHT to toggle between TEMP and
PANL
5. Press TEMP to toggle ON or OFF
6. Press LIGHT to exit
PROGRAMMING (connued)
UNLOCK (ALLOWING PANEL OPERATION)
This unlock sequence may be used from any screen
that may be displayed on a restricted panel.
1. Press and hold down TEMP UP
2. Slowly press the LIGHT buon twice
3. The panel with display the UNLK message